You can get creative with how you use your pins. Whether you choose a handful of specific colors, or opt for an assortment pack, you can take your map planning to a new level with colored pins! That’s why we offer so many personalizations for your map, including the assortment of colored map push pins for you to choose from. For best results, make sure you are using the correct tack for your job to avoid damage.Your personalized map should be as unique as you are. Snagging on vinyl or fabric-covered boards will cause the material to run, leaving unappealing ripples in the material. Pins that have burrs or bent over points will pull off cork when they are removed, which will cause holes to be more obvious. If a staple is ripped out of a cork board, you run the risk of pulling out a chunk of the board, leaving an obvious blemish on the board. Typically staples can be used for the same purpose as pins or tacks but must be taken out with care when removing. Staples are often misconstrued as pin alternatives. Use small and gentle taps to avoid leaving a hammer mark and damaging your corkboard sheet. If you intend to place the finishing nail in permanently, be sure to take caution with your hammer. If removed, the nail may make a permanent hole. They can also be helpful when sewing since they hold fabric together nicely./p>įinishing nails should not be used unless they are meant to be a permanent part of your cork board. T-pins are commonly used for pinning patterns and model building. These tacks are somewhat stronger than other tacks and can be pushed into other surfaces than cork such as fiberboard, soft plywood, and plywood. These are normally ⅜” long, but can come in a variety of different lengths. Push pins are the “traditional” looking tacks. Map pins come in a variety of different colors, which is helpful for their use in showing different points on a map. These consist of a round ball grip at the end, making it easier to hold and pull out of the cork. Like thumb tacks, the point of map pins are usually ¼” long. Thumb tacks are a good way to hang your papers without drawing much attention. Since they lay flat on the board, they can be more difficult than other tacks to remove. If you are shopping for Pre-Framed Tack Boards by Bangor Cork discover our broad selection of products produced by craftsmen in our Pennsylvania shop., Framed Cork Boards & Bulletin BoardsĪ thumb tack point is normally ¼” long. If using the correct type of pin, NATURAL and COLORED boards both have the ability to hide pin holes by expanding after the pin is removed from the board. It’s important to know what to use, and what not to use, when pinning something to your board in order to avoid damage. So why the need for all the different types of tacks?ĭifferent tacks and pins serve different purposes. Have you ever gone down the aisle of an office supply store and wondered why there are so many different types of tacks? It seems simple enough - you have a cork sheet, you have something to hang, and you tack it up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |